We jump into Cheetah3D<\/a> again, and the first thing we do is to make a copy of the complete rope structure, both sides, copy it and move it down. A rope bridge usually have one rope that you hold onto, and one that hold onto the planks.<\/p>\n Now, we need some ropes that goes from the top to the bottom rope on each side, which stabilize the bridge. First, we need another rope texture, so back into FilterForge<\/a> again. We create this, a little darker rope texture, for the thin ropes.<\/p>\n Now, a pretty tedious work to add all those small ropes. Creating a very thin cylinder, then placing in in position. As the left side is at exactly -2.0 in local coordinates, and the right side at +2.0, making a copy and just move it by entering the new X-position is quite fast.<\/p>\n Here you can see all the middle section ropes, the distance is a little wider at the center of the bridge.<\/p>\n Now, we need some ropes that anchors the bridge into the ground, preventing it from collapsing, and the ropes the bad guys always cuts in the movies. A cylinder with a torus ring at the lower end, and the other end just into the rope rings a the pole.<\/p>\n Then we create large nail that holds the rope tight, a box, stretched, with an old iron texture to it.<\/p>\n![\"\"](\"http:\/\/4eyes.code66.se\/wp-content\/uploads\/2010\/05\/ropeb2-01.jpg\" "\\"ropeb2-01\\"")
<\/a><\/p>\n<\/a><\/p>\n<\/a><\/p>\n<\/a><\/p>\n<\/a><\/p>\n